Design Request Dehumidifier Selection Tool Swimming Pool Heat Loss Heat Pump Warranty Registration Before & After Sales Services Shipping Policy Corporate Culture
Skip to content
SPS – Static Pressure Switch

SPS – Static Pressure Switch

$ 162.86 CAD

Notify me when back in stock

Payments:  Credit Cards paypal bank transfer

Return Policy: We accept return within 30 days of receipt of your orders. Restocking fee applies on some returned Products. Returned Items shall have intact labels, packages and shall not have been used. for more info.

  • refund Full refund if you do not receive your ordered items. 
  • refund Partial Refund for partially not received or damaged items
  • Description
  • Technical Documents

Introduction

  1. The Static Pressure Switch, Model SPS, is used to sense the supply air duct’s static pressure and control the modulating by-pass damper (Models ZDM or RDM) in order to maintain the duct system air pressure. When used on a zone control system, the supply air static pressure increases as various zone dampers close down.
  2. The increase in static pressure can become noisy and reduce the volume of air through the HVAC Unit, if the static overcomes the rating of the blower. The SPS controls this by sensing the increased static and signaling the modulating by-pass damper to open. As the by-pass damper opens to relieve the excess static, the air pressure in the duct decreases. The damper responds to the control signal of the SPS. When the static pressure rises above 0.3”W.C., the SPS will power the motorized by-pass damper open.
  3. As the by-pass damper opens the duct static should decrease below this higher setting of 0.3” and as it does the damper stops. If other zone dampers open and the static continues to fall below the lower setting of 0.2” W.C., the by-pass damper will close. The two setpoints of 0.2” and 0.3” and the SPST contacts for each, provide the control for the bypass damper to truly modulate to prevent excessive static in the system.

  • Manual