Design Request Dehumidifier Selection Tool Swimming Pool Heat Loss Heat Pump Warranty Registration Before & After Sales Services Shipping Policy Corporate Culture
Skip to content
Round Take-off Zone Dampers - RTP Model - 12VDC Plug in Play

Round Take-off Zone Dampers - RTP Model - 12VDC Plug in Play

$ 391.10 CAD
Diameter

Notify me when back in stock

Payments:  Credit Cards paypal bank transfer

Return Policy: We accept return within 30 days of receipt of your orders. Restocking fee applies on some returned Products. Returned Items shall have intact labels, packages and shall not have been used. for more info.

  • refund Full refund if you do not receive your ordered items. 
  • refund Partial Refund for partially not received or damaged items
  • Decription
  • Technical Documents

  • Introduction

    The RTP series are galvanized steel, single blade dampers compete with a 12 Volt DC motor actuator. This Round Take-Off Damper combines both a take-off collar and motorized damper into one unit and is shipped complete and ready for installation. The RTP can be installed in any position on any properly sized duct. All RTP dampers are rated for duct systems less than 2.0” W.C.
    Dampers are available in 6”, 8”, 10”, 12”, 14” and 16” diameters. Dampers are ordered as RTPdd, using 2 digits for each dimension.
    A 12 Volt DC damper motor, Model MP12M, powers the RTP. The motor powers the damper closed and open. The MP12M motor wires by simply plugging the motor in using the modular cord, supplied with each damper. The modular cord is a 25’ length of standard four (4) conductor telephone wire with RJ11 jacks on each end. The motor is complete with 2 jacks allowing you to daisy chain up to 10 dampers per zone.
    The MP12M motor has been tested to over 1,000,000 cycles to provide long life. Even replacing the motor is a simple less than one (1) minute change by loosening the setscrew holding the motor onto the damper, slide the motor off the damper shaft, place a new one on and secure with the screw.
    The RTP motor also has a two-color Light Emitting Diode (LED) to indicate the damper position. When the LED is GREEN the damper is Open. When the LED is RED the damper is Closed. When the LED is not lit the motor is typically moving between open and closed. The motor cycles between open and closed in less than 5 seconds.

  • Manual